Work hard! It’s not hard to get certified! Share the latest Cisco ICND2 200-105 exam dump for free. online 200-105 exam practice tests. the latest 200-105 exam questions and answers, and guarantee your skills and exam experience! “Interconnecting Cisco Networking Devices Part 2 (ICND2)” – 200-105 exam! pass4itsure.com expert recommendation! Top pass rate!
Get the latest Cisco ICND2 200-105 pdf
[PDF] Free Cisco 200-105 pdf dumps download from Google Drive: https://drive.google.com/open?id=1Ur9hoWqgjbHgga0B07WW72cSFO_cbYbh
[PDF] Free Full Cisco pdf dumps download from Google Drive: https://drive.google.com/open?id=1xM4qOTLaMDVyi16Ta0wO8qvdS21TfgOU
Valid information provided by Cisco officials
The latest Cisco ICND2 200-105 exam practice questions test your strength
Which six-byte field in a basic Ethernet frame must be an individual address?
Correct Answer: C
When using the CLI, which banner displays a message upon every connection that is made into the router?
Correct Answer: C
Which two marking methods are supported with the IPv4 header? (Choose two.)
Correct Answer: AB
After you configure a GRE tunnel between two networks, the tunnel comes up normally, but workstations on each side
of the tunnel cannot communicate.
Which reason for the problem is most likely true?
A. The tunnel source address is incorrect.
B. The tunnel destination address is incorrect.
C. The route between the networks is undefined.
D. The IP MTU is incorrect.
E. The distance configuration is missing.
Correct Answer: D
What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame
Relay hub in a hub-and-spoke topology?
A. It avoids split-horizon issues with distance vector routing protocols.
B. IP addresses can be conserved if VLSM is not being used for subnetting.
C. A multipoint interface offers greater security compared to point-to-point subinterface configurations.
D. The multiple IP network addresses required for a multipoint interface provide greater addressing flexibility over point-
Correct Answer: B
You do not have to assign a separate subnet per sub-interface. If you\\’re using a Class A network (10.x.x.x/8), you blow
the whole network on a few connections (if you used VLSM, you could use a better mask, limit the addresses used). if
you used 10.0.0.0/8, you would not be assigning the entire /8 to a single network. You would select a subnet mask for
the network and then, you would have to use that mask with all subnets of the network. So if you chose a /24 mask, that
would mean that you would have to use a /24 mask for even point-to-point links.